Stevenson 1002
Lower Screen:
- Power screen control switch is on the wall. Move switch to down position.
Turn On Data Projector:
- Make sure Main Power switch on side of remote control is "on"
- Point remote at Data Projector
- Press the "On" Button
To Use the Mac:
- Press "DATA 1" on the Data Projector Remote to select "RGB1"
on the Data Projector.
- Press the power up button located on the lower right corner of the Mac.
To Use a Laptop:
- Press "DATA 2" on the Data Projector Remote to select "RGB2"
on the Data Projector.
- Connect your laptop and proceed in its normal start up.
To Use the Document Camera ( ELMO Visual Presenter):
- Press "VIDEO1" on the Data Projector Remote to select "VIdeo
1" on the Data Projector.
- Turn the power on by pressing the power switch located on the left
side of the visual presenter, near the back
- Make sure the input on the ELMO is set to "Internal"
To Use the VCR:
- Follow the Document Camera Iistructions above except that the input should be set to "AV1"
- Gently insert the tape to be used into the VCR.
- If VCR does not automatically begin playing, press the "Play" button on the VCR
Adjusting the Sound Using The Remote Control:
- Adjust the Volume by pressing the VOLUME UP-DOWN button on the remote
control
Laser Pointer Function On The Remote Control:
- Press the LASER POINTER button to activate the laser pointer.
