Art 102
Lower Screen:
- Power screen control switch is on the wall. Move switch to the down position.
Turn On Data Projector:
- Make sure Main Power switch on side of remote control is "on"
- Point remote at Data Projector
- Press the "On" Button
Select Device On Data Projector:
- Select "Data 1" to use the Mac: Press the power up button located at the upper right corner of the key board
- Select "Data 2" to use a PC
- Select "Video 1" to use the Visual Presenter or VCR:
Visual Presenter (Elmo):
- Turn the power on by pressing the power switch located on the left
side of the visual presenter, near the back
- Make sure the input is set to "Internal"
VCR:
- On the visual presenter, set the input to "AV1"
- Gently insert the tape to be used into the VCR
- If VCR does not automatically begin playing, press the "Play" button on the VCR
Adjusting The Picture And Sound Using The Remote Control:
- Adjust the Volume by pressing the VOLUME UP-DOWN button on the remote
control
- See "Adjusting the Picture" and "Adjusting the Audio" attached to this instruction sheet for adjusting the picture brightness, (contrast, etc.), as well as audio bass & treble
Laser Pointer Function On The Remote Control:
- Press the LASER POINTER button to activate the laser pointer.
